4
Disassembly/Assembly > Original Exposure System > Removing the Copyboard Glass Unit > Procedure
5) Remove the Reader Unit [1].
• 2 Shafts [2]
[1]
CAUTION:
• When disassembling/assembling the Reader Unit, be careful not to damage the Flat
Cables and harnesses with [A] part.
• Be sure to put the Flat Cables and harnesses through the [A] part before installing
the Copyboard Cover Unit and Reader Unit when assembling.
[A]
4
Disassembly/Assembly > Original Exposure System > Removing the Copyboard Glass Unit > Procedure
[2]
F-4-38
F-4-39
Removing the Copyboard Glass Unit
■ Preparation
1) Remove the Control Panel Unit.(Refer to page 4-29)
■ Procedure
CAUTION:
Be sure to place the removed Copyboard Glass Cover on a cloth, etc. to avoid
damaging the bottom sheet.
When removing the Copyboard Glass, be careful not to touch the glass surface.
If the surface becomes dirty, clean it with lint free paper.
4-21
F-4-40
4-21