Adjust - Canon M3010 Series Service Manual

ADJUST

Display area
▲▼ buttons
Canon MF3010 USM Ver.1.01
USM
Canon MF3010 Service Control Tool
Set up CANON MFP ( USB Service Mode)
MODE COPIER
STATUS
DISPLAY ADJUST ADJUST
ADJ-XY ( RANGE : -30 to 30 )
ADJ-X
0 RD
CCD ( RANGE : 128 to 384 )
FB-TARGET-R
128 RD
FB-TARGET-B
128 RD
PRINT ( RANGE : 50 to 150 )
TOP-CST
50
RD
TEST PRINT button
RD button Obtain the current value of each setting.
WR button Send the value of each display area to the machine.
Operation becomes possible by pressing the corresponding RD button.
▲▼ buttons Increase or decrease a value of each display area.
Operation becomes possible by pressing the corresponding RD button.
Display area Display each value.
Apart from using the ▲▼ buttons, you can also enter a value directly from the
keyboard.
TEST PRINT Perform the test print using values set in TOP-CST and LEFT-CST.
button Before performing the test print, be sure to load A4 or LTR paper.
8
Service Mode > COPIER > ADJUST
RD button WR button
ON
TESTMODE Show MEMO
Connected Close
FUNCTION COUNTER TYPE
ADJ-X-MG
WR 0 RD WR
FB-TARGET-G
WR 128 RD WR
FB-TARGET-BW
WR 128 RD WR
LEFT-CST
50
WR RD WR
TEST PRINT
F-8-4
8 Service Mode > COPIER > ADJUST
NOTE:
• Even if a value of a display area is changed, the change is not reflected until pressing the
WR button.
• By pressing the TEST PRINT button, the following screen appears and the machine is
waiting for output.
T-8-4
8-5
F-8-5
8-5