Indoor Unit Installation - Toshiba RAS-M10PKVP-E Service Manual

10-3-6. Indoor Unit Installation

1. Pass the pipe through the hole in the wall, and
hook the indoor unit on the installation plate at
the upper hooks.
2. Swing the indoor unit to right and left to confi rm
that it is fi rmly hooked on the installation plate.
3. While pushing the indoor unit onto the wall, hook
it at the lower part on the installation plate.
Pull the indoor unit toward you to confi rm that it is
fi rmly hooked on the installation plate.
4. Pull the connecting cable through the cable slot
on the rear panel so that it protrudes about 15 cm
out of the front.
1
2
Hook
Fig. 10-3-19
• For detaching the indoor unit from the installation
plate pull the indoor unit toward you while pushing
the bottom up at the specifi ed places.
Push
Push
Fig. 10-3-20
Hook here
[1] Installation plate
Push (unhook)
10-3-7. Drainage
1. Run the drain hose at a downward sloped angle.
NOTE:
Hole should be made at a slight downward slant on
the outdoor side.
OK
Do not rise the drain hose.
50 mm
or more
2. Put water in the drain pan and make sure that the
water is being drained outside.
3. When connecting extension drain hose, insulate
the connection part of extension drain hose with
shield pipe.
Shield pipe
Drain hose Inside the room
Install the drain pipe for proper drainage.
Improper drainage can result in water dripping
inside the room.
This air conditioner has been designed to drain
water collected from condensation which forms on
the back of the indoor unit, to the drain pan.
Therefore, do not locate the power cord and other
parts at a high place above the drain guide.
– 60 –
NO GOOD
Do not form the drain hose
into the waved shape.
Do not put the Do not put the drain
drain hose end hose end in the
into water. drainage ditch.
Fig. 10-3-21
Extension drain hose
Fig. 10-3-22
CAUTION
Wall
Drain
guide
Space for
pipes
Fig. 10-3-23