Toshiba RAS-M10PKVP-E Service Manual page 58

10-3-5. Piping and Drain Hose Installation
Piping and drain hose forming
Since condensation results in machine trouble,
make sure to insulate both the connecting pipes
separately.
(Use polyethylene foam as insulating material.)
Rear right
Rear left
Bottom left
Left
Bottom right
Right
Fig. 10-3-10
Relocating drain hose
For left connection, left-bottom connection and rear-
left connection's piping, it is necessary to relocate
the drain hose and drain cap.
1. Cutting front panel slit.
Cut out the slit on the left or right side of the front
panel for the left or right connection and the slit
on the bottom left or right side of the front panel
for the bottom left or right connection with a pair
of nippers.
2. Remove the drain cap
Clamp drain cap with needle-nose pliers, and pull
out.
Fig. 10-3-11
3. Remove the drain horse
The drain hose is secured in place by a screw.
Remove the screw securing the drain hose, then
pull out the drain hose.
Screw
Fig. 10-3-12
Drain hose
4. Attach the drain cap
• Insert hexagonal wrench (4 mm).
4 mm
5. Firmly insert drain cap.
No gap
Insert a hexagon
wrench (Ø4mm)
6. Attach the drain hose
Insert the drain hose fi rmly until the connector
contacts with the insulation, then secure it in
place using the original screw.
Always use the original screw that secured
the drain hose to the unit.
If using a different screw may cause water
to leak.
Securely insert the drain hose and drain cap;
otherwise, water may leak.
NOTE:
The packaged foam polystyrene can
be used to make replacement of the
drain cap and drain hose easier.
Piping on the right side or the left side
• After making slits on the front panel with a knife or
similar tool, cut them out with a pair of nippers or
an equivalent tool.
Slit
– 58 –
Fig. 10-3-13
Do not apply lubricating oil
(refrigerant machine oil)
when inserting the drain cap.
If applied, deterioration and
drain leakage of the drain
plug may occur.
Fig. 10-3-14
CAUTION
Foam polystyrene Foam polystyrene
of package of package
Fig. 10-3-15
Unit Unit