Toshiba RAS-M10PKVP-E Service Manual page 107

No. Part name
TE sensor (outdoor heat exchanging temperature sensor)
k
• Attachment
With the sensor leads pointing in the direction shown in the
fi gure, install the sensor onto the straight pipe part of the
condenser output pipe.
TS sensor (Suction pipe temperature sensor)
l
• Attachment
With its leads pointing downward, point the sensor in the
direction of the packed valve, and install it onto the straight
pipe part of the suction pipe.
TD sensor (Discharge pipe temperature sensor)
m
• Attachment
With its leads pointed downward, install the sensor facing downward onto the vertical straight pipe part
of the discharge pipe.
TO sensor (Outside air temperature sensor)
n
• Attachment
Insert the outdoor air temperature sensor into the holder, and install the holder onto the heat exchanger.
TGa/TGb sensor (Gas side pipe temperature sensor)
o
• Attachment
With its leads pointing downward, point the sensor in the direction of the front cabinet, and install the
sensor onto the straight pipe part of gas side pipe. Match the sensor protective tube colors with the
pipe marking colors and install the sensors. TGb is red.
TD sensor TS sensor
Detail A, B, D
During the installation work (and on its completion), take care not to damage the
coverings of the sensor leads on the edges of the metal plates or other parts. It is
dangerous for these coverings to be damaged since damage may cause electric
shocks and/or a fi re.
After replacing the parts, check whether the positions where the sensors were installed are the
proper positions as instructed. The product will not be controlled properly and trouble will result if
the sensors have not been installed in their proper positions.
Procedure
Detail C
TE sensor
TGb sensor
(RED)
TGa sensor
CAUTION
– 107 –
Remarks
Arrow E
Detail D
Detail C
Detail A Detail B
Arrow E
TO sensor