Installation Of Indoor Unit - Toshiba RAS-M10SMUV-E Installation Manual

WARNING
Install the air conditioner certainly to sufficiently withstand the weight.
If the strength is insufficient, the unit may fall down resulting in human injury.
Perform a specified installation work to guard against an earthquake.
An incomplete installation can cause accidents by the units falling and dropping.
Remote controller
• Should be placed where there are no obstacles, such as
curtains, that may block the signal.
• Do not install the remote controller in a place exposed to direct
sunlight or close to a heating source such as a stove.
• Keep the remote controller at least 1 m away from the nearest TV
set or stereo equipment. (This is necessary to prevent image
disturbance or noise interference.)
• The location of the remote controller should be determined as
shown the right.

4 INSTALLATION OF INDOOR UNIT

WARNING
The installation of the air conditioning unit must be positioned in a location that can sufficiently support its weight and give
protection against adverse environmental conditions. Failure to do so may result in unit damage and possible human injury. Any
incomplete installation may also cause possible risk of human injury.
• Unpack the package, take out the product and then place it on the floor so that the same surface directs underneath as it is
placed in the package.
• Never put the products in a pile or put weight on them, which are taken out from
the packing box; otherwise there is a possibility to damage electric parts, fan
parts, draining mechanism, and etc.
If the both sides are turned over, a deformation of mounting metal of the ceiling
panel which is sold separately, etc. may be caused. Accordingly the product may
be damaged and the installation becomes impossible in some cases.
REQUIREMENT
Strictly comply with the following rules to prevent damage of the indoor units and human injury.
• Do not place heavy objects on the indoor unit. (Even when units are still packaged)
• Always carry the unit as packaged from the factory wherever possible. If carrying in the indoor unit unpacked by necessity,
be sure to use buffering cloth, etc. to prevent damaging the unit.
• To move the indoor unit, hold the hanging brackets (4 positions) only. Do not apply force to other parts (refrigerant pipe, drain
pan, foamed parts, or resin parts etc.).
• To be carried by two or more people. Do not strap the unit in positions other than stated.
EN
Sensor part
Ceiling panel
Signal-receiving range
6
Ceiling panel base
Remote controller
OK NO GOOD