Name And Functions Of Indications On Remote Controller - Toshiba RAS-M10PKVP-E Service Manual

9-4-2. Name and Functions of Indications on Remote Controller

[Display]
All indications, except for the clock time indicator, are displayed by pushing the
1
Transmission mark
This transmission mark ▲ indicates when the
remote controller transmits signals to the indoor
unit.
2
Mode indicator
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover
control, : Cool,
3
Temperature indicator
Indicates the temperature setting. (17°C to 30°C)
4
PURE indicator
Shows that the electrical air purifying operation is
in progress.
5
FAN speed indicator
Indicates the selected fan speed.
AUTO or fi ve fan speed levels (LOW ,
LOW+ , MED
HIGH ) can be shown.
Indicates AUTO when the operating mode is
either AUTO or : Dry.
6
TIMER and clock time indicator
The time setting for timer operation or the clock
time is indicated.
The current time is always indicated except during
TIMER operation.
7
Hi POWER indicator
Indicates when the Hi POWER operation starts.
Push the Hi POWER button to start and push it
again to stop the operation.
1
2
3
4
AUTO
9 7
: Dry, : Heat)
, MED+ ,
10
8
5 6
8
(MEMORY) indicator
Flashes for 3 seconds when the MEMO button is
pressed during operation.
The mark is shown when holding down the
button for 3 seconds or more while the mark is
fl ashing. Push another button to turn off the mark.
9
SLEEP mode indicator
Indicates when the SLEEP MODE is in activated.
Push the SLEEP MODE button to start and push
it again to stop operation.
10
A, B change indicator remote controller
When the remote controller switching function is
set, "B" appears in the remote controller display.
(When the remote controller setting is "A", there is
no indication at this position.)
NOTE:
Remote controller switching function
• If two indoor units are installed in the same room
or adjoining rooms, both units may start and stop
at the same time when the remote controller is
operated.
This can be prevented by setting the switching
function so that each indoor unit is operated only
by the corresponding remote controller.
– 50 –
button.