Cancel The Auto Restart Function; Power Failure During Timer Operation - Toshiba RAS-M10PKVP-E Service Manual

9-3-2. Cancel the Auto Restart Function

To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the signal and beeps 3 times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
• When the system is on stand-by (not operating)
Operation
Push [RESET] button for more than
3 seconds. (Less than 10 seconds)
• When the system is operating
Operation
Push [RESET] button for more than
3 seconds. (Less than 10 seconds)

9-3-3. Power Failure During Timer Operation

When the unit is turned off because of power failure during timer operation, the timer operation is cancelled.
In that case, set the timer operation again.
NOTE :
The Everyday Timer is reset while a command signal can be received from the remote controller even if it
stopped due to a power failure.
The unit is on standby.
↓
The unit starts to operate.
↓
The unit beeps 3 times and continues to operate.
If the unit is not required to operate at this time, push [RESET] button
once more or use the remote controller to turn it off.
The unit is in operation.
↓
The unit stops operating.
↓
The unit beeps 3 times.
If the unit is required to operate at this time, push [RESET] button once
more or use the remote controller to turn it on.
– 48 –
Motions
(Push [RESET] button for more than 3 seconds.)
The green indicator is on.
After approx. 3 seconds,
Motions
The green indicator is on.
(Push [RESET] button for more than 3 seconds.)
The green indicator is turned off.
After approx. 3 seconds,