Draytek Vigor2920 Series User Manual page 164

Item
After finishing all the settings here, please click OK to save the configuration.
D e t a i l s
D e t a i l s
There are two configuration pages for LAN1, Ethernet TCP/IP and DHCP Setup (based on
IPv4) and IPv6 Setup. Click the tab for each type and refer to the following explanations for
detailed information. Below shows the settings page for IPv6.
It provides 2 daemons for LAN side IPv6 address configuration. One is RADVD(stateless)
and the other is DHCPv6 Server (Stateful).
Available settings are explained as follows:
Item
RADVD Configuration
Vigor2920 Series User's Guide
Description
If you want to use the router as a DNS proxy server, you have
to input router's LAN IP into the Primary or Secondary DNS
server IP fields manually.
P a g e f o r L A N 1 – I
P a g e f o r L A N 1 – I
Description
Enable – Click it to enable RADVD server. The router
advertisement daemon (radvd) sends Router Advertisement
messages, specified by RFC 2461, to a local Ethernet LAN
periodically and when requested by a node sending a Router
Solicitation message. These messages are required for IPv6
P v 6 S e t u p
P v 6 S e t u p
154