Load Default Setup; Clear All Data - ADT A-ADRP4E-120 User Manual

User's Manual
You can use other functions on the DVR while video is being backed up. To do this, highlight
the Close button and press the button. You can return to the Clip Copy screen at any time to
check the progress.
NOTE: You can not end the archiving process during CD burning.
Refer to Appendix B — Reviewing Backup (Clip) Images for instructions on how to review the
images you have backed up.
NOTE: During clip copy, you cannot change the system date and time, shut the system
down, switch to the Quick Setup mode, clear all data, and change the system setup from
a remote site.
CAUTION: Do NOT disconnect the USB cable or the power from the external
drive while backing up video. If the external drive is shut down or the USB cable
is disconnected while backing up, THE DVR SYSTEM MAY NOT WORK
NORMALLY OR THE EXTERNAL DRIVE COULD BE DAMAGED, and you will get
an error message the next time you try to back up. You will need to power down
the DVR and restart it to get rid of the error message. Once the file system of the
USB-IDE hard disk drive has been corrupted, this error message cannot be
dismissed. Even after restarting the DVR it may automatically restart while
preparing a backup. You must recover the file system using the recovery
program, or you must reformat the hard disk drive.

Load Default Setup

Highlighting and selecting Load Default Setup will bring up a screen asking you if you really
want to load default settings and confirm it with a password.
NOTE: Loading the Default Setup will not change the current time, time zone, daylight
saving time and network settings.

Clear All Data

Highlighting and selecting Clear All Data will bring up a screen asking you if you really want
to clear all data and confirm it with a password.
CAUTION: Selecting Clear All Data will erase all recorded video.
64