Table of Contents
Advertisement
User's Manual
To change the time format, highlight the box beside Time Format and press the
button. The
DVR toggles between 12 Hours (AM/PM) and 24 Hours (military time).
You can save your changes by highlighting OK and pressing the
button . Selecting Cancel
exits the screen without saving the changes.
System Check Screen
Highlight System Check in the Main menu and press the
button. The System Check
setup screen appears.
Figure 32 — System Check screen.
Highlight the box under the On/Off heading and press the
button. This toggles between On
and Off. When it is On, the DVR reports a fault condition if it does not detect any recording or
if there is an alarm during the designated time.
Highlight the box under the Interval heading and press the
button. A slide bar appears
allowing you to set the check interval from 1 Hour to 30 Days by using the Left and Right arrow
buttons.
The Status field displays the fault conditions. When it is Good, there was recording or an
alarm occurred during the designated time. When it is Bad, there was no recording or no alarm
occurred during the designated time.
Highlight the box beside the On Record Problem: Alarm Out and press the
button. A drop
menu displays the available alarm outputs for the recording problem. Highlight the desired
alarm output from no alarm output, external alarm out terminal or internal buzzer, and press the
button.
24
Advertisement
Table of Contents
