Load Default Setup; Clear All Data - ADT A-SDR400LTE-80 User Manual

User's Manual
NOTE: During clip copy, you cannot change the system date and time, shut the system down,
switch to the Quick Setup mode, clear all data, and change the system setup from a remote
site.
NOTE: The recording speed will be decreased to 1 ips per camera during CD burning, or while
the DVR is preparing clip copy data on hard disk drive.
CAUTION: Do NOT use poor quality CD-R or CD-RW discs or ones that have been
scratched or damaged in any way.
CAUTION: Do NOT disconnect the USB cable or the power from the external drive
while backing up video. If the external drive is shut down or the USB cable is
disconnected while backing up, THE DVR SYSTEM MAY NOT WORK NORMALLY
OR THE EXTERNAL DRIVE COULD BE DAMAGED, and you will get an error
message the next time you try to back up. You will need to power down the DVR
and restart it to get rid of the error message. Once the file system of the USB-IDE
hard disk drive has been corrupted, this error message cannot be dismissed. Even
after restarting the DVR it may automatically restart while preparing a backup. You
must recover the file system using the recovery program, or you must reformat the
hard disk drive.

Load Default Setup

Highlighting and selecting Load Default Setup will bring up screen asking you if you really want
to load default settings and confirm it with a password.
NOTE: Loading the Default Setup will not change the current time, time zone, daylight saving
time and network settings.

Clear All Data

Highlighting and selecting Clear All Data will bring up screen asking you if you really want to
clear all data and confirm it with a password.
CAUTION: Selecting Clear All Data will erase all recorded video.
58