Table of Contents
Advertisement
User's Manual
Main Monitoring Setup Screen
You can adjust the display dwell time for each camera displayed on the main monitor. You can
also turn camera sequence and event monitoring on and off.
Figure 61 — Main Monitoring Setup screen.
Highlight the box beside Sequence Dwell Time and press the
button. You can adjust the
sequence dwell time from 3 to 60 seconds.
Highlight the box beside Sequence in Cameo and press the
button to toggle between On
and Off. (Not on 4-camera model.)
Pressing the
SEQUENCE
button causes the DVR to sequence cameras, and the DVR can
sequence cameras in two modes: "Page" and "Cameo". In the Page mode, the DVR sequences
through user-defined screen layouts (pages). In the Cameo mode, the bottom right window in a
multi-screen format sequences through all cameras.
NOTE: The DVR does not sequence the camera having video loss in the Cameo mode.
You can define the screen layout in a variety of formats and set the DVR to sequence through
the different screen layouts (pages) so that all the cameras will be displayed. You can also set
up the DVR to display one camera or a group of cameras all the time while cycling through the
remaining cameras in a "cameo" window. This can be done with one camera displayed full
screen while displaying the cameo window as a PIP (picture in picture), or displaying the
cameras in a grid pattern with the bottom right window as the cameo.
NOTE: Sequence cannot be used in the 4x4 display mode of the 16-channel, 3x3 mode
of the 9-channel and the 2x2 mode of the 4-channel DVR.
52
Advertisement
Table of Contents
