Table of Contents
Advertisement
User's Manual
Network Setup Screen
In the Network Setup screen you can set up the DVR for LAN connections.
Figure 63 — Network Setup screen.
Highlight the box beside Connection. Press the
button to toggle between LAN and
Modem.
Highlight the box beside Admin Password and press the
button. A virtual keyboard
appears. You will first be asked to enter the current password. Then you can enter a new
password; you will be asked to confirm the new password before it is accepted.
Highlight the box beside User Password and press the
button. A virtual keyboard appears.
You will first be asked to enter the current password. Then you can enter a new password; you
will be asked to confirm the new password before it is accepted.
NOTE: These passwords are for network use. They are different from the Admin and
User passwords for the DVR itself.
NOTE: The passwords are case sensitive. The factory default password for both
Administrator and User is 12345678.
CAUTION: Write the password down and keep it in a safe place. Once the
password has been reset, the default will no longer work. If the password is
forgotten, the unit must be reset using the Factory Reset Button and all data
settings will be lost.
Highlight the box beside Transfer Control. Press the
button to toggle between On and Off.
When it is On, you can set the transfer speed and remote quality of the image transferred to a
computer running RAS (Remote Administration System).
54
Advertisement
Table of Contents
