System Check Screen; Figure 26 - System Check Screen - ADT A-SDR400LTE-80 User Manual

Highlight the Run as Server box and press the
between On and Off. When it is On, the DVR you are setting up will run as a time server.
You can save your changes by highlighting OK and pressing the
the screen without saving the changes.
Highlight the box beside Date Format and press the
Highlight the format you wish to use and press the
To change the time format, highlight the box beside Time Format and press the
DVR toggles between 12 Hours (AM/PM) and 24 Hours (military time).
You can save your changes by highlighting OK and pressing the
the screen without saving the changes.

System Check Screen

Highlight System Check in the Main menu and press the
screen appears.
Highlight the box under the On/Off heading and press the
Off. When it is On, the DVR reports a fault condition if it does not detect any recording or if there
is an alarm during the designated time.
Highlight the box under the Interval heading and press the
you to set the check interval from 1 Hour to 30 Days.
button. Pressing the
button. A list of date formats appears.
button. The choices are:
MM-DD-YYYY
DD-MM-YYYY
YYYY-MM-DD
MM/DD/YYYY
DD/MM/YYYY
YYYY/MM/DD
Figure 26 — System Check screen.
Four-Channel Digital Video Recorder
button toggles
button . Selecting Cancel exits
button. The
button . Selecting Cancel exits
button. The System Check setup
button. This toggles between On and
button. A slide bar appears allowing
19