TEC B-470 SERIES Maintenance Manual page 42

6. DIAG. TEST OPERATION
2) Parameters
#
Character code selection
(11)
Font zero selection
(12) Control code selection
(13) Ribbon type selection
(14) Feed length fine adjustment
(19) (PC), (KEY)
(15) Cut/strip position fine adjustment
(20) (PC), (KEY)
(16) Back feed length fine adjustment
(21) (PC), (KEY)
(17) Print tone fine adjustment
(22) (Thermal transfer ) (PC), (KEY)
(18) Print tone fine adjustment
(23) (Thermal direct) (PC), (KEY)
(24) X axis fine adjustment
(25) Threshold manual fine adjustment for
the black mark sensor
(26) Threshold manual fine adjustment for
the feed gap sensor
(27) Ribbon Motor
(28) STATUS
(29) Kanji code type
(Not supported by QQ/QP models)
(30) MOTOR
EURO font code setting
(31)
(32) Transmission Control Mode
(33) Reset selection when the
INPUT • PRIME signal is ON.
Item
PC-850 :
PC-8
0
0
AUTO
ESC LF NUL
{ }
1B 1C 1D
TRANS.
NON TRANS. :
-50.0 mm to +50.0 mm
-50.0 mm to +50.0 mm
-9.9 mm to +9.9 mm
-10 step to +10 step
-10 step to +10 step
-99.5 mm to +99.5 mm
0.0V to 4.0 V
0.0V to 4.0 V
-15 Strip to +0 Step
1: Strip wait status is not sent to the PC.
2: Strip wait status is sent to the PC.
TYPE1:
TYPE2:
TYPE1:
TYPE2:
20H to FFH
DTR: READY/BUSY (DTR) protocol (DTR/DSR)
RTS: READY/BUSY (RTS) protocol (RTS/CTS)
ON:
OFF: The printer will not restore to the initial status.
Contents
PC-850
: PC-8
: No slash used.
: Slash used.
: Automatic selection
: ESC LF NUL mode
: Mainframe mode
: Manual
: Transmissive ribbon
Non-transmissive ribbon
Windows code
Original code
SANYO motor
NMB motor
The printer will restore to the initial status.
6-5
EM18-33011
(Revision Date: Dec. 10 '99)
6.2 SELF TEST MODE