TEC B-470 SERIES Maintenance Manual page 29

3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
4. Pass the take-up harness of the rewinder ass'y and the longer harness of the rewind full sensor
through the hole of the main frame. Connect the take-up harness and rewind full sensor harness
to CN15 and CN5 on the CPU PC board respectively. Fix the harness at two points with the clamps.
5. Connect the connector of the rewind full sensor (LED) with the other harness of the rewind ass'y.
6. Align the notch of the take-up holder with the screw hole of the rewinder ass'y and attach it to the
printer with four FL-4 x 6 screws.
7. Attach the rewind full sensor (LED) to the base with SM-3 x 6B screw.
Rewind Full Sensor (LED)
Screw (SM-3x6B)
Notch
Rewinder Ass'y
NOTE: You should change the selection switch position depending on the usage of the take-up holder.
Improper setting can affect the print quality.
STANDARD/PEEL OFF (STRIP):
REWINDER:
For the cutter type, the selection switch can be set to either position.
Rewind Sensor Harness
Opening
Take-up Holder
CN5
Clamp
FL-4x6
Selection switch
FL-4x6
Batch and strip types
Built-in rewinder type
3-9
3.5 Strip Module (B-4905-H-QM)
CPU PC Board
CN15
Take-up Harness
EM18-33011
Fig. 3-12