TEC B-470 SERIES Maintenance Manual page 24

3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
5. Connect the take-up/cutter harness to CN1 on the Cutter I/F PC board and CN15 on the CPU PC
Board, then fix it with the clamp.
CPU PC Board
Take-up/Cutter Harness
6. Mount the cutter cover with the two white screws.
Cutter Cover
7. Reassemble the left side cover and the top cover in the reverse order of removal.
8. After reassembly is complete, perform a test print to confirm that the cutter works properly.
After printing a print sample at a speed of 6"/sec., feed the media about 33 mm and check that the
swing cutter works without error. After cutting the media, feed the media about 33 mm in the reverse
direction and check that it correctly stops at the print start position.
NOTES: 1. If the top edge of label winds onto the platen in cut issue, set DIP SW. 1-5 to ON.
(Refer to the Owner's Manual)
2. Retain the parts that are removed during installation of the cutter unit. They will be required
when the printer is modified to a standard type.
Removed Parts
Front plate
Removed Parts
Q'ty/Unit
Black screws
1
Clamp
Screw
Q'ty/Unit
2
3-4
EM18-33011
(Revision Date: Sep. 27 '94)
3.2 Cutter Module (B-4205-QM)
Cutter Unit
Cut I/F PC Board
Connector (CN1)
Fig. 3-5
Cutter Attaching Screw
Fig. 3-6