TEC B-470 SERIES Maintenance Manual page 39

6. DIAG. TEST OPERATION
Type II
The parameter setting such as feed length fine adjustment or cut/strip position fine adjustment can be
changed while the printer is on-line or printing. Pressing the [PAUSE] key causes the printer to enter
parameter setting mode. Reset mode is provided for this procedure to cancel the steps which follow the
[PAUSE] key without turning the power off.
Press the [PAUSE] key.
(See NOTE 3.)
Press the [FEED] key
and [RESTART] key
at the same time.
NOTES: 1. Pressing the [PAUSE] key during printing causes the printer to pause printing and show the
number of remaining media.
2. If the [RESTART] key is released within 3 seconds, the printer will resume printing because
the [RESTART] key is activated.
3. Since the reset is performed when terminating this mode, the printer cancels the remaining
media and returns to on-line mode. This reset will not clear the changed parameter settings.
Power on
O N L I N E
Press the [PAUSE] key. (See NOTE 1.)
P A U S E
Hold down the [RESTART] key for
more than 3 seconds. (See NOTE 2.)
< 1 > R E S E T
Press the [RESTART] key.
< 2 > P A R A M E T E R
Press the [PAUSE] key.
Refer to Section 6.3 Parameter Setting Mode
for the following procedure.
Press the [RESTART] key.
6.1 OUTLINE OF THE DIAG. TEST OPERATION
5
S E T
6-2
(Revision Date: Sep. 27 '95)
Indicates the number of
remaining media when the
[PAUSE] key is pressed.
EM18-33011