Pitney Bowes DM125 Operator's Manual page 160

10 • Maintenance
Replacing the Print Head
8. Remove the protective tape or the black cap from the bottom of the
replacement print head.
Protective Tape
9. Squeeze the two gray tabs on either side of the new print head
and slightly angle the print head while pushing the print head
flush against the wall.
10. If you are using the same ink cartridge you removed in Step 5,
continue with step 11.
Otherwise, if you are putting in a new ink cartridge, remove tape
on bottom of new ink tank cartridge.
10-10
OR
Black Cap
Flush Against Wall
Tabs
SV62667 Rev. A