48 Installing and configuring the VCS One Policy Master
Configuring the Policy Master
Choosing a storage architecture to configure
Configuring disaster recovery
Symantec recommends that you use a shared storage architecture for storing
the configuration database. You can configure Storage Foundation if you are in
the process of installing Storage Foundation, or it is already on your system.
Otherwise, you can configure NetApp filer or another storage architecture.
To select and configure a storage architecture
1
At the Storage Architecture prompt, select the storage architecture you want
to configure.
2
See
Table 2-1
for details on the remaining configuration tasks.
Table 2-1
VCS One configuration task details
To configure
Storage Foundation as part of the
installation and configuration
process
Storage Foundation when it is
already installed on your system
NetApp filer, or another storage
architecture
Follow the steps in this section to specify if you want to configure disaster
recovery.
For information about disaster recovery, see
recovery" on page 39.
Deciding when to configure disaster recovery
You can configure disaster recovery during the VCS One installation and
configuration process, or you can configure it after installing and configuring
VCS One.
Complete these tasks
1
"Configuring disaster
2
"Configuring Storage
3
"Starting the Policy
Master" on page 54
1
"Configuring Storage
2
"Configuring disaster
3
"Starting the Policy
Master" on page 54
1
"Configuring your storage
page 51
2
"Configuring disaster
3
"Starting the Policy
Master" on page 54
"Preparing to configure disaster
recovery" on page 48
Foundation" on page 51
Foundation" on page 51
recovery" on page 48
architecture" on
recovery" on page 48