Table of Contents
Advertisement
You see a list of information that you need to prepare so that you can add
the system.
3
Press Enter.
Configuring the Policy Master cluster
You must specify an ID for the Policy Master cluster, and configure the
heartbeat settings.
For instructions, see the following topics:
■
"Creating an ID for the Policy Master
■
"Configuring the heartbeat
Entering the NIC for the Policy Master virtual IP address
To enter the NIC for the Policy Master virtual IP address
1
Enter the NIC for the Policy Master Virtual IP address to use on your system.
From the list of NIC devices discovered on your systems, select any NIC that
is up and running on a public network. For example, enter the following:
■
(On Linux) eth0
(On Solaris x64) bge0
■
2
At the Policy Master virtual IP address configuration verification prompt,
confirm that the virtual IP address is correct. Enter y.
Entering the NICs for disaster recovery
To enter the NICs for disaster recovery
1
For each unique virtual IP address, enter the public NIC. For example, enter
the following:
■
(On Linux) eth0
(On Solaris x64) bge0
■
2
At the disaster recovery configuration verification prompt, verify that the
virtual IP address and NIC information is correct. Enter the following: y.
Verify the VCS One operations on the new system
To verify the VCS One operations on the new system
1
Check the status of your Policy Master cluster. Enter the following:
# /opt/VRTSvcsone/bin/haadmin -state
Adding a new or replacement system to the Policy Master cluster
Adding a system to the Policy Master cluster
cluster" on page 45.
settings" on page 45.
111
Advertisement
Table of Contents
Troubleshooting
