Table of Contents
Advertisement
Select Dialog Boxes That Appear to End Users
Configure Installation Types
Wise Installation Studio/Express Getting Started Guide
To determine the level of control the end user has over the installation, you specify
which dialog boxes appear during installation. In this procedure, you set up the
QuickFacts installation to let the end user choose which features to install.
Select dialog boxes that appear to end users
1.
Under the User Interface page group, select the Dialogs page.
2.
Mark the check boxes for the Installation Type Dialog and the Select Feature Dialog.
3.
Leave the defaults for the rest of the dialog boxes.
The selected dialog boxes will appear during installation. The Installation Type Dialog
lets the end user choose from a Typical, Complete, or Custom installation, and the Select
Feature Dialog lets the end user select features in a custom installation.
In the next section, you define which features are installed with each type of installation.
You can define which features are installed when the end user selects Complete, Typical,
or Custom on the Installation Type dialog box. On the Installation Types page, you turn
features on or off for each type of installation.
To configure installation types
1.
Under the User Interface page group, select the Installation Types page.
The upper-left list box shows three installation types by default, Typical, Complete,
and Custom, which correspond to the three radio buttons presented to the end user
on the Installation Types dialog box during installation.
2.
In the upper-left list box, select &Typical. (The & indicates which letter will be
underlined for the shortcut key.)
3.
Make sure the Default Installation Type button is unavailable; if not, click it. This
sets the Typical installation as the default.
4.
In the list on the right, make sure the check boxes are marked for Core, Birds, and
Cats, as shown below. Clear the Dogs check box. (The features might be listed in a
different order in your installation.)
5.
In the upper-left list box, select &Complete and, in the list box on the right, make
sure the check boxes are marked for all features.
6.
In the upper-left list box, select C&ustom and, in the list on the right, make sure
the check boxes are marked for the Core, Birds, and Cats. Make sure the Dogs
check box is cleared, as shown below. (The features might be listed in a different
order in your installation.)
Basic Tutorial: Creating a Windows Installer Installation
26
Advertisement
Table of Contents
