Table of Contents
Advertisement
22 Getting ready to install VCS One
Running installation prechecks
Running installation prechecks
Logging on and mounting the product disc
To open the required ports on Linux
1
Log on as a user who has the privileges to change the firewall configuration.
2
Set up the table of IP packet filter rules for each of the ports you want to
open. Enter the following:
iptables -I INPUT -p tcp --dport port -j ACCEPT
iptables -I OUTPUT -p tcp --dport port -j ACCEPT
Where
is the port number. Specify
port
for an outbound port. For example, the commands to open the
OUTPUT
required ports for the VCS One client on Linux are:
iptables -I INPUT -p tcp --dport 14154 -j ACCEPT
iptables -I OUTPUT -p tcp --dport 14151 -j ACCEPT
iptables -I OUTPUT -p tcp --dport 14159 -j ACCEPT
For each software installation, you can check the target systems before
installation to verify that:
■
The system has enough disk space for the installation.
■
The product being installed is not already installed.
Follow the instructions in this section to mount the product disc on Solaris,
Linux, AIX, or HP-UX.
To log on and mount the product disc
1
Log on as root on a system where you want to install VCS One.
2
Insert the product disc into a DVD drive connected to your system.
3
Mount the VCS One software disc. For details, see the appropriate section for
your platform:
For Solaris, see the next section
■
on
Solaris."
■
For Linux, see
page 23.
■
For AIX, see
"Mounting the product disc on
■
For HP-UX, see
INPUT
"Mounting the product disc manually
"Mounting the product disc manually on
"Mounting the product disc on
for an inbound port, and
Linux" on
AIX" on page 23.
HP-UX" on page 23.
Advertisement
Table of Contents
Troubleshooting
