Table of Contents
Advertisement
116 Upgrading from VCS One 2.0.1 to 5.0
Upgrading the Policy Master
Upgrading the Policy Master
Adding a system to a VCS One 5.0 Policy Master cluster
Exporting your VCS One 2.0.1 configurations
This section provides instructions on upgrading the Policy Master, including:
■
"Adding a system to a VCS One 5.0 Policy Master
■
"Exporting your VCS One 2.0.1
■
"Deleting a system from your VCS One 2.0.1 Policy Master
page 117
■
"Importing your 2.0.1 configurations to VCS One
■
"Migrating your 2.0.1 configurations to VCS One
This subsection provides instructions on creating a cluster ID and specifying the
Policy Master virtual IP address:
■
"(Optional) Creating an ID for the VCS One 5.0 Policy Master cluster and
specifying the virtual IP
See
Chapter 9, "Adding a new or replacement system to the Policy Master
cluster"
for instructions on adding a system to your Policy Master cluster.
Follow the steps in this section to export your VCS One 2.0.1 configurations to a
local drive, or to a remote location. This process exports the Symantec Product
Authentication Service (AT) and database configurations.
Verifying VCS One operations on the new system
To verify VCS One operations on the new system
◆
Check that the Policy Master service group is online. Enter the following:
# /opt/VRTSvcsone/bin/hagrp -state
Exporting your configurations
To export your configurations
1
Navigate to the directory that contains the export script. For example, enter
the following:
# cd /mnt/rhel5_x86_64/cluster_server_one/
2
Run the export utility. Enter the following:
# ./installvcsonepm -export
configurations" on page 116
addresses"
cluster" on page 116
cluster" on
5.0" on page 118
5.0" on page 120
Advertisement
Table of Contents
Troubleshooting
