(Optional) Creating An Id For The Vcs One 5.0 Policy Master Cluster And Specifying The Virtual Ip Addresses; Verifying That The Vcs One 5.0 Policy Master Service Group Is Online; Creating An Id For The 5.0 Policy Master Cluster And Specifying The Virtual Ip Address - Symantec XGS-4728F Installation Manual

122 Upgrading from VCS One 2.0.1 to 5.0
Upgrading the Policy Master
(Optional) Creating an ID for the VCS One 5.0 Policy Master cluster
and specifying the virtual IP addresses
For the remaining migration steps, see the following sections:
■ "Configuring the Policy Master
■ "Specifying the authentication services port
■
"Configuring virtual IP addresses for the Policy
■
"Choosing a storage architecture to
■
"Configuring your storage
■ "Configuring disaster
■ "Starting the Policy
Follow the steps in this section to create an ID for your VCS One 5.0 Policy
Master cluster, and specify the Policy Master virtual IP addresses.
Verifying that the VCS One 5.0 Policy Master service group is
online
To verify that the VCS One 5.0 Policy Master service group is online
◆
Enter the following:
# /opt/VRTSvcsone/bin/hagrp -state
Creating an ID for the 5.0 Policy Master cluster and
specifying the virtual IP address
To create an ID for the 5.0 Policy Master cluster and specify the virtual IP
address
1 Navigate to the directory that contains the upgrade script. For example,
enter the following:
# cd /mnt/rhel5_x86_64/cluster_server_one/
2 Run the command for creating an ID for the Policy Master cluster and
specifying the virtual IP address. Enter the following:
./installvcsonepm -cidvip
3 Enter the name of the system for which you want to create an ID for the 5.0
Policy Master cluster and specify a virtual IP address. For example, enter
the following:
my_machine2
cluster" on page 44
configure" on page 48
architecture" on page 51
recovery" on page 48
Master" on page 54
number" on page 46
Master" on page 46