Synchronizing The Clock Times On Your Systems; Completing And Verifying The Installation - Symantec XGS-4728F Installation Manual

Synchronizing the clock times on your systems

The clock times between the client and Policy Master systems within the same
time zone must be within 30 minutes of one another or the installation may fail.
If the clock times are more than 1000 seconds apart, you see a warning.
To synchronize the clock times on your systems
1
2
3

Completing and verifying the installation

To complete and verify the installation
1
2
3
4
Do one of the following:
If you do not see a warning about the clock times, go to the section
■
"Completing and verifying the
■ If you see a warning about the clock times, go to
At the clock time discrepancy prompt, decide if you want to continue
configuring the client. Do one of the following:
■ To continue configuring the client, enter y.
■ To stop configuring the client, enter n.
If you want to synchronize the clock times, use the ntpdate command. For
example, enter the following:
rdate ntphost
At the verification prompt, verify that the virtual IP addresses, base IP
addresses, root broker hash, and the SSL library path (if configured) are
correct. Enter the following: y.
At the start client prompt, choose whether to start the VCS One client
processes. Do one of the following:
■ Follow the prompt to start the vcsoneclientd processes. Enter y.
■ Wait until later to start the vcsoneclientd processes. Enter n.
When you are ready to start the client processes, you must enter the
following:
#
/opt/VRTSvcsone/bin/hastart -client
To view the installation logs. Enter the following:
#
/var/VRTS/install/logs/
On the Policy Master, verify that the client is up and running. Enter the
following:
#
hasys -state
On the client, enter the following:
#
ps -ef | grep vcsone
Installing and configuring the VCS One client
Configuring the VCS One client
installation."
step 2.
73