Table of Contents
Advertisement
44 Installing and configuring the VCS One Policy Master
Configuring the Policy Master
Configuring the Policy Master
Starting the Policy Master configuration
Configuring the Policy Master cluster
To install Policy Master now,
but configure it later
During the configuration process, you configure your Policy Master cluster. The
installer also gives you the option to configure disaster recovery, and Storage
Foundation or NetApp.
The configuration procedures are in the following subsections:
■
"Starting the Policy Master
■
"Configuring the Policy Master
■
"Specifying the authentication services port
■
"Configuring virtual IP addresses for the Policy
■
"Choosing a storage architecture to
■
"Configuring disaster
■
"Configuring your storage
■
"Starting the Policy
If you have not yet started the Policy Master configuration, do so now.
To start the Policy Master configuration
1
Start the VCS One configuration. Enter the following:
#
./installvcsonepm -configure
2
Enter the names of the systems on which you want to configure the VCS One
Policy Master. Separate each name with a space. Do not enter fully-qualified
domain names or IP addresses. For example, enter the following: sys1
sys2
You must provide a host name for the Policy Master cluster. If you install the
Policy Master on two or more systems, you must also provide a numerical ID
number and configure heartbeat settings.
Enter the following: n.
The installer installs the packages, and you can
configure the Policy Master later. When you are ready
to configure, see the next section:
"Configuring the Policy
configuration" on page 44
cluster" on page 44
configure" on page 48
recovery" on page 48
architecture" on page 51
Master" on page 54
Master."
number" on page 46
Master" on page 46
Advertisement
Table of Contents
Troubleshooting
