Setting The Default Platform In The Vcs One Cluster; About Configuring Vcs One - Symantec XGS-4728F Installation Manual

Table 2-4
Table 2-5
the Policy Master uses disaster recovery. The table contains the resources you
see when you configure two virtual IP addresses for disaster recovery.
Table 2-5

Setting the default platform in the VCS One cluster

You may want to make changes at the VCS One cluster level. For example, you
can set the default platform to match the platform that is most prevalent in your
VCS One cluster. If you set the default platform, fewer users have to specify the
platform name.
To set the default platform in the VCS One cluster
◆

About configuring VCS One

Each system in a VCS One cluster has a unique host name and IP address. In
addition, VCS One uses attributes to match systems and users. The system-level
attribute, SysUserName, which is initially NULL, contains the name of the VCS
PMSG resources when the Policy Master uses NetApp (continued)
Resource Description
Monitors ICMP connectivity between the Policy Master and
pmfiler
the NetApp filer
VCS One web console
VCSOneWeb
describes the DRSG resources in the haadmin -status output when
DRSG resources when the Policy Master uses disaster recovery
Resource Description
Disaster recovery service group
DRSG
The DRApp resource that manages the disaster recovery
dr_app
service group (DRSG
Disaster recovery virtual IP address 1
drip1
Disaster recovery virtual IP address 2
drip2
NIC device for disaster recovery virtual IP address 1
drnic1
NIC device for disaster recovery virtual IP address 2
drnic2
Set the default platform in the VCS One cluster. Enter the following:
#
/opt/VRTSvcsone/bin/haclus -modify DefaultPlatform
platform
Installing and configuring the VCS One Policy Master
After you install the Policy Master
57