Configuring Netapp - Symantec XGS-4728F Installation Manual

Configuring NetApp

VCS One can use NFS for storing configuration information. Only
NetApp filers are supported as NFS servers. During installation, the
configuration must be mounted on the first node.
The following information is required to configure the database on
NetApp filers:
-- Mount point
-- IP address / hostname for NetApp filer
Note: The entries for the Policy Master nodes should exist in the
/etc/hosts directory on the NetApp filer.
-- NetApp filer access method
-- rsh (requires passwordless access between the Policy Master node
and the NetApp filer)
-- ssh (requires passwordless access between the Policy Master node
and the NetApp filer)
-- API (uses the NetApp SDK)
-- Username for accessing filer
-- Password for accessing filer in case of API access mode
-- IP address / hostname for the NIC connected to the filer for each
Policy Master system
-- File System Path on NetApp filer used to store the VCS One
configuration
Enter the mount point for the Configuration Database: [b,q,?]
/software/vcsone
Enter the fully qualified hostname or IP Address of the NetApp
filer: [b,q,?]
netapp3.veritas.com
NetApp filer access method
Select the access method to access the NetApp filer: [1-3,b,q,?] (1)
3
Enter the username to be used to access the NetApp filer: [b,q,?]
(root)
Enter the password for root:
Enter again:
Enter the hostname or IP Address for NIC on thoropt158: [b,q,?]
(thoropt158)
Enter the hostname or IP Address for NIC on thoropt159: [b,q,?]
(thoropt159)
Enter the exported path on the NetApp filer where VCS One
configuration would be stored: [b,q,?]
/vol/rgriffit_vol/vcsone
Do you wish to use API over SSL? [y,n,q,b,?] (n) y
Enter the SSL library path (version 0.9.8 or greater): [b] /lib
Veritas Cluster Server One 5.0.0 by Symantec
1) Use rsh
2) Use ssh
3) Use api
b) Back to previous menu
Sample installation output
Installing the VCS One Policy Master with NetApp
183