Stamping Originals - Canon iR3530 Manual

Stamping Originals

The feeder directly applies a stamp (about 3 mm in diameter) on the front side of originals after
scanning them, so that you can distinguish already scanned originals from others.
2
IMPORTANT
• The Stamp mode cannot be used with the Document Size Select (Other Size) modes.
• The Stamp mode cannot be used when sending a fax document in the Direct Sending mode.
NOTE
The Stamp mode can be set only if the optional Feeder (DADF-N1) is attached.
1
2-14
Sending Methods
Position at which
stamp is applied.
Vertical placement
Place your originals in the feeder.
NOTE
For instructions on placing your original, see Chapter 2, "Basic Operations," in the Reference
Guide.
Position at which
stamp is applied.
Horizontal placement