Reception Password; Receive Password - Canon iR3530 Manual

Be sure to enter a pause after the prefix code. If you press [Pause] at the end of the prefix
code, <P> is displayed. If you do not insert a pause, the prefix code is not registered.
You can enter up to 20 digits for a prefix code.
Press [Backspace] to delete the last character that you entered.
You can press
If you select [Hooking]:
• Press [OK].
The specified mode is set.

Reception Password

This function enables you to set an optional ITU-T standard password.
If a subaddress is not set in a document that was received from another party using the ITU-T
standard, an RX password check takes place.
If the RX password found does not match the RX password set with this mode, or if an RX
password is not attached to the document, the document is not received.
IMPORTANT
When receiving a document by specifying a memory box, the password of the memory box takes
precedence over an ITU-T standard password.
NOTE
ITU-T: This is the department of the International Telecommunication Union which sets communication
standards.
1
Press

[Receive Password].

to clear your entry.
[System Settings] [Communications Settings]
Communications Settings
6
6-21