Table of Contents
Advertisement
Grey Headline (continued)
Status
The
IP status
page provides details of the IP and DNS settings of the VCS.
To view the
IP status
page:
•
Status > System > IP
The information shown on this page will vary depending on your system configuration, but may
include the following information:
IP
Protocol
Indicates the IP protocol supported by the VCS.
IPv4: The VCS will only accept registrations from endpoints using an
IPv4 address, and will only take calls between two endpoints or devices
communicating via IPv4. It will communicate with other systems via IPv4
only.
IPv6: The VCS will only accept registrations from endpoints using an IPv6
address, and will only take calls between two endpoints communicating
via IPv6. It will communicate with other systems via IPv6 only.
Both: The VCS will accept registrations from endpoints using either an
IPv4 or IPv6 address, and will take calls using either protocol. If a call is
between an IPv4-only and an IPv6-only endpoint, the VCS will act as an
IPv4 to IPv6 gateway (note that this will require a traversal call licence).
The VCS can communicate with other systems via either protocol.
IPv4 gateway
The IPv4 gateway used by VCS.
IPv6 gateway
The IPv6 gateway used by VCS.
Dual Network
Indicates whether the second LAN port has been enabled. This is done
Interfaces
by installing the Dual Network Interfaces option key.
LAN 1
Shows the IPv4 address and subnet mask, and IPv6 address of the
LAN 1 port.
LAN 2
If the Dual Network Interfaces option key has been installed, this shows
the IPv4 address and subnet mask, and IPv6 address of the LAN 2 port.
DNS
Server 1..5 address
The IP address(es) of each of the DNS servers that will be queried when
resolving domain names. Up to 5 DNS servers may be configured.
Domain
Specifies the name to be appended to the host name before a query to
the DNS server is executed.
Overview and
Introduction
Getting started
status
D14049.05
February 2009
IP status
System
VCS
configuration
configuration
The
Resource Usage
page provides statistics about the numbers of current and cumulative calls
and registrations on the VCS. This page automatically refreshes every 5 seconds.
To view the
Resource usage
•
Status > System > Resource usage
The page displays the following information:
Traversal calls
Current: The number of traversal calls going through the VCS at this
moment.
Max
the VCS since it was last restarted.
Total: The total number of traversal calls handled by the VCS since it was
last restarted.
Non-traversal calls
Current: The number of non-traversal calls going through the VCS at this
moment.
Max
by the VCS since it was last restarted.
Total: The total number of non-traversal calls handled by the VCS since it
was last restarted.
Registrations
Current: The number of devices registered to the VCS at this moment.
Max
VCS since it was last restarted.
Total: The total number of registrations on the VCS since it was last
restarted.
Zones and
Call
Bandwidth
neighbors
processing
control
32
TANDBERG
VIDEO COMMUNICATIONS SERVER
Resource usage
page:
(peak): The highest number of concurrent traversal calls handled by
(peak): The highest number of concurrent non-traversal calls handled
(peak): The highest number of devices concurrently registered to the
Firewall
Applications
Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices
Advertisement
Table of Contents
