Table of Contents
Advertisement
Grey Headline (continued)
Tools
The
Check pattern
page
(Maintenance > Tools > Check
or transform you intend to configure on the VCS will have the expected result.
Patterns can be used when configuring:
•
Allow Lists
and Deny
Lists, to specify aliases to be included in the list
•
pre-search transform
s, to specify aliases to be transformed before they are searched for locally
•
Local Zone matche
s
and
zone
matches, to filter searches based on the alias being searched for,
and to transform an alias before the search is executed to that zone.
To use this tool:
Alias
Enter the alias against which you will test the transform.
Pattern
In the
Pattern
section, enter the combination of Pattern,
tested. If you have selected a
Behavior
of Replace, you will also need to enter a
Check pattern
Click here to test whether the alias matches the pattern.
The
Result
section will show whether the alias matched the pattern, and if so, the resulting
transformed alias.
Overview and
Introduction
Getting started
status
D14049.05
February 2009
Check pattern
pattern) allows you to test whether a pattern
Type
and
Behavior
for the pattern being
Replace
System
VCS
configuration
configuration
The
Locate
page
(Maintenance > Tools >
endpoint identified by a given alias, within a specified number of 'hops', without actually placing a
call to that endpoint. The results will include the list of zones that were searched, any transforms
and Call Policy that were applied, and if found, the zone in which the alias was located.
This tool is useful when diagnosing dial plan and network deployment issues.
To use this tool:
Alias
Enter the alias you wish to locate.
Hop count
Enter the number of hops for the search.
Protocol
Select whether the search will be initiated using H.323 or SIP. The search may be interworked
string.
during the search process, but the VCS will always search all zones at a given priority using the
native protocol first, before searching those zones again using the alternative protocol.
Locate
To initiate the search, click Locate.
The status bar will show
Searching...
will show whether or not the alias was found, any transforms that were applied, and the zones that
were searched in order of priority.
When searching for an alias, the VCS will first search all the highest-priority zones using the
protocol of the incoming call. If the search was unsuccessful the VCS may then search the
same zones again using the alternative protocol, depending on where the search came from
and the
Interworking mode (VCS configuration > Protocols >
unsuccessful, the VCS will then move on to the next highest priority zones, first searching in the
native protocol and then in the alternative protocol.
The
Locate
tool initiates a search as though the VCS received a call request from a remote system,
rather than a locally registered endpoint. Therefore if
the VCS will search the Local Zone using both protocols, and all other zones using the native
protocol only (because it will interwork the call only if one of the endpoints is locally registered).
If
interworking mode
is set to On, the VCS will search the Local Zone and all external zones using
both protocols.
Zones and
Call
Bandwidth
neighbors
processing
control
165
TANDBERG
VIDEO COMMUNICATIONS SERVER
Locate
Locate) allows you to test whether the VCS can find an
followed by
Search
completed. The body of the status section
Interworking), If this search is
interworking mode
is set to
Firewall
Applications
Maintenance
traversal
ADMINISTRATOR GUIDE
Registered
only,
Appendices
Advertisement
Table of Contents
