Table of Contents
Advertisement
Grey Headline (continued)
Restoring default configuration
It is possible to restore the VCS to its default configuration. This is done using the CLI using
xCommand
DefaultValuesSet. This command is not available using the web interface.
DefaultValuesSet
The
command allows you to specify the level of configuration to restore, from
1 to 3 as follows:
•
Level 1
resets most configuration items to their default value, with the exception of the items
shown in the table below. The
xConfiguration reference
items and where applicable their default values.
•
Level 2
is not currently used, so setting this level has the same effect as setting Level 1.
•
Level 3
resets all configuration items to their default value, including those shown in the table
below.
Configuration item
Administration TimeOut
Applications ConferenceFactory Alias
Applications ConferenceFactory Mode
Applications ConferenceFactory Template
Applications OCS Relay Mode
Applications OCS Relay OCS Domain
Applications OCS Relay OCS Routing Prefix
Applications Presence Server Mode
Applications Presence Server Publication ExpireDelta
Applications Presence Server Subscription ExpireDelta
Applications Presence User Agent ExpireDelta
Applications Presence User Agent Mode
Applications Presence User Agent RetryDelta
Ethernet [1..2] IP V4 Address
Ethernet [1..2] IP V4 StaticNAT Address
Ethernet [1..2] IP V4 StaticNAT Mode
Overview and
Introduction
Getting started
status
D14049.05
February 2009
table shows a full list of all configuration
DefaultValuesSet level 3
System
VCS
Zones and
configuration
configuration
neighbors
Overview
xCommand DefaultValuesSet Level: 3
!
system's IPv4 and IPv6 addresses, meaning you will no longer be able to access the system
over IP. It also deletes all option keys including pre-installed options such as Expressway
and the number of calls.
xCommand DefaultValuesSet Level: 3
!
including the automatically configured
Subzone and Default Zone. Without these links, calls will not be able to be placed. To
restore these links, you should run the command
DefaultValuesSet Level:
3. These links can also be restored manually using the web
interface - see the section
Creating links
Default value after xCommand DefaultValuesSet Level: 3
0
<blank>
Off
<blank>
Off
<blank>
ocs
Off
120
300
3600
Off
5
192.168.0.100
<blank>
Off
Call
Bandwidth
processing
control
168
TANDBERG
VIDEO COMMUNICATIONS SERVER
must be used with caution, as it resets the
also deletes all links configured on the VCS,
default links
between the Default Subzone, Traversal
xCommand DefaultLinksAdd
for instructions on how to do this.
Firewall
Applications
Maintenance
traversal
ADMINISTRATOR GUIDE
xCommand
after
Appendices
Advertisement
Table of Contents
