Cn-2675G Board - Sony HDCU2500 Maintenance Manual

2. Remove the rear sub assembly (included in the HIF-62 board and the SDI-99 board) . (Refer to
Board")
Procedure
1. Disconnect the flexible flat cable from the connector CN106 on the SDI-99 board.
2. Remove the three screws to detach the shield finger (BNC) and the SDI-99 board.
CN106
SDI-99 board
3. Install the removed parts by reversing the steps of removal.
4-6-3.

CN-2675G Board

Preparation
1. Remove the rear panel assembly. (Refer to
2. Remove the HIF-62 board. (Refer to
3. Remove the SDI-99 board. (Refer to
Procedure
1. Remove the two screws of the round type connector (8P).
Round type connector (8P)
2. Disconnect the flexible flat cables from the connectors CN7 and CN10 on the CN-2675G board.
HDCU2500
Flexible flat cable
Shield finger
"4-4-1. Removal and Installation of Rear Panel
"4-6-1. HIF-62 Board")
"4-6-2. SDI-99 Board")
P2.6 x 5
B3 x 5
Assembly")
"4-6-1. HIF-62
4-22