Table of Contents
Advertisement
3-10.
CN-3958 Board
Preparation
1.
Remove the cover. (Refer to
2.
Remove the AT-196 board. (Refer to
Procedure
1.
Disconnect the flexible flat cable (45 core) from the connector (CN1) on the CN-3958 board.
2.
Open the three clampers, then remove the harness.
3.
Remove the six screws (BTP3 x 10) and four screws (BTP2.6 x 10), then remove the CN-3958 board in the direction
of the arrow.
Clampers
Flexible flat cable
(45 core)
4.
Install the removed parts by reversing the steps of removal.
HXCU-FB80
"3-2.
Cover".)
"3-8. AT-196 Board and Lithium
Harness
Clamper
CN1
The illustration shows LEMO model.
Battery".)
CN-3958 board
BTP
2.6 x 10
BTP
2.6 x 10
BTP
3 x 10
3-15
Hide quick links:
Advertisement
Table of Contents
