Hkcu-Fp1 Ccu Control Panel (Optional) - Sony HXCU-100 Operating Instructions Manual

HKCU-FP1 CCU Control Panel (Optional)

The switches and knobs not described below are identical to those on the front panel. See "Front Panel" on page 10.
a PANEL ACTIVE button
Activates the optional HKCU-FP1 CCU Control Panel to
control the camera connected to the CCU (panel active state).
When the button is lit, the IRIS/MB ACTIVE indicator also
turns on simultaneously. When the button is not lit, the optional
panel is deactivated (lock state) to prevent inadvertent
operation.
b SW1, SW2 (assignable switch 1, 2) buttons
Controls the function assigned to each button on the <FRONT
PANEL 1> page in the CCU CONFIGURATION menu. The
button light turns on/off as the assigned function is switched
on/off.
See "ASSIGNABLE/CUSTOM" on <FRONT PANEL 1> on
page 26.
c BARS (color bars) button
Switches on the color bar signal output to the monitor
connected to the CCU (button light turns on). Pressing the
button again restores the previous signal output.
d STANDARD button
Stores the current camera settings as the reference file data
values in the camera (button light turns on for a few seconds).
While the button is lit, pressing the button again cancels the
operation and restores the previous data values.
e SHUTTER controls
Controls the shutter settings.
ON button
ECS (extended clear scan) button
Display
UP/DOWN lever
• ON button
Switches the normal shutter function on/off (button light turns
on/off).
• ECS (extended clear scan) button
Switches the extended clear scan function on/off (button light
turns on/off).
• Display
When the ECS button is lit: Displays the clear scan frequency.
When the ON button is lit: Displays the shutter speed.
a b c d e f
h i j k l
• UP/DOWN lever
When the ECS button is lit: Adjusts the clear scan frequency.
UP increases the frequency, and DOWN decreases the
frequency.
When the ON button is lit: Adjusts the shutter speed. UP
increases the shutter speed, and DOWN decreases the
shutter speed.
Holding the lever UP or DOWN advances the setting in that
direction.
f MASTER GAIN controls
Controls the video output signal gain in response to the
lighting of the subject.
Display
UP/DOWN lever
• Display
Displays the video output signal gain setting (dB units).
• UP/DOWN lever
Adjusts the video output signal gain setting (dB units).
UP increases the gain, and DOWN decreases the gain.
Holding the lever UP or DOWN advances the setting in that
direction.
g ALARM indicator
Lights up red to indicate an error in the CCU or camera
system.
h CALL button
Sends a call signal to the camera connected to the CCU and
any external controller (such as the MSU-1000/1500 Master
Setup Unit or RCP-1000-series Remote Control Panel).
The CALL button is commonly used to raise the camera
operator or external control equipment operators on the
intercom.
i CUSTOM (custom volume) knob
Controls the function assigned to the knob on the <FRONT
PANEL 1> page in the CCU CONFIGURATION menu. Turning
the knob adjusts the assigned function.
See "VOLUME" on <FRONT PANEL 1> on page 27 and
"CUSTOM" on <FRONT PANEL 2> on page 27.
g
Optional panel controls
m
Locations and Functions of Parts
13