Installing The Hkcu-951 - Sony HDCU-950 Installation And Maintenance Manual

1-7-8. FC-88 Board (HKCU-953)
A B
1
FC
D103
POWER
2
D105
CONVERT
3
FRAME
D104
REF IN
UN
D107
LOCK
4
5
D103 (green) : POWER display
Lights up when the voltage used on this board is normally
supplied.
D104 (green) : SUB REF IN display
Lights up when the sub reference for frame lock is input.
D105 (green) : CONVERT display
Lights up when the shooting mode of the camera is set to
24PsF and the 60i or 50i signal is output from the HKCU-
953.
D107 (red) : UNLOCK display
Lights up when the frame reference signal is not synchro-
nized with the main reference signal.
HDCU-950 IMM
C D E
FC-88 board (A side/panel side)

1-8. Installing the HKCU-951/953

1-8-1. Installing the HKCU-951
Installation
Front side (EN-145 board)
1. Turn off the power and disconnect the power cord
from the wall outlet.
2. Loosen the two screws (with drop-safe) and open the
front panel in the direction of the arrow.
Front panel
Screw
(with drop-safe)
Screw (with drop-safe)
3. Insert the EN-145 board in the right most blank slot.
n
Check that the EN-145 board is securely connected to
the motherboard (MB-951 board).
1-7. Functions of Indicators on Boards
1-8. Installing the HKCU-951/953
EN-145 board
1-27 (E)