Figure 2-38 Idle Terminal Display; Figure 2-39 Confirm Ring Time Display - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
Press Exit, terminal returns to idle display.
Remote Inspection
To use the Remote Inspection feature target destination setting is necessary.

When Remote Inspection is set to the terminal, Confirm and Ring Time are displayed on

Multiline Terminal LCD.
If Remote Inspection set terminal is busy (receiving another incoming call or on active

calls), an inspection ring starts after finishing the previous call.
If the VRS message is not recorded, a warning tone instead of a VRS message is sent.

A target dial can be programmed by using Service Code (Program 11-10-49).

Outside call routing follows the settings in Program 13-05-1 Abbreviated Dialing.

When Program 13-05-01 set to 0, an outside call route is referring to Program 14-06-01

setting and search data from route table 100 of order 4 in descending order. If Program
14-06-01 set to 0, no outside call is provided.
If outgoing call restriction is set in a system, an emergency call cannot go through. In case

of using outgoing call restrictions, toll restriction Class 1 is followed.
Auto outgoing call via leased line cannot go through when all trunks are busy.

When trunks are all busy, the emergency call does not complete. In this case, Alarm Type

33 is provided.
Security

Figure 2-38 Idle Terminal Display

Figure 2-39 Confirm Ring Time DIsplay

Issue 13.0
2 - 1351