Lexmark MX610 Service Manual page 156

Error code
80B
80C
80D
80E
811
812
813
814
815
818
819
81A
880
881
Description
Too many errors when transmitting in ECM
mode.
Remote device failed to respond to the CTC
command.
Received too many requests from remote end
to repeat the previous command sent.
Functional limitation-Remote fax device does
not support G3 receive capability.
Failed to detect a fax device at the remote end.
No more data rates available in V34 modulation
scheme.
Timeout occurred after waiting too long to
receive a good frame.
Tried too many times at selected speed using
V34 modulation scheme.
Fax transmission was interrupted due to power
failure.
Fax transmission failed due to insufficient
memory to store scanned image.
Fax transmission failed due to insufficient
memory to store received image.
A timeout occurred during transmission of a
page in ECM mode.
Failure to transmit training successfully in V17,
V29, V27 terminal modulation schemes.
Failure to transmit training successfully in V33,
V29, V27 terminal modulation schemes.
Diagnostic information
Action
•
Check line quality.
•
Adjust 'Transmit Level'.
•
Select a lower 'Max Speed' value under
Fax Send settings.
•
Select a lower 'Max Speed' value under
Fax Send settings.
•
Adjust 'Transmit Level'.
• Check line quality.
• Adjust 'Transmit Level'.
•
Check if line conditions on remote end
will facilitate a good connection.
No action needed. Issue with the remote
device.
•
Verify MFD is answering to fax call and
not a voice call.
•
Decrease value of 'Rings To Answer'
setting.
Adjust to a lower modulation scheme.
Adjust "Receive Threshold".
•
Adjust 'Transmit Level'.
•
Adjust to a lower modulation scheme.
Troubleshoot MFP if error persists. See
"Modem/fax card service check" on
page 150.
Adjust 'Memory Use' setting to allocate
more memory for send jobs.
Adjust 'Memory Use' setting to allocate
more memory for receive jobs.
Select a lower 'Max Speed' value under Fax
Send settings.
•
Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
•
Select a lower "Max Speed" under Fax
Send settings.
•
Adjust the "Transmit Level".
•
Check line quality.
156
7016