Lexmark MX610 Service Manual page 104

Error code Description
42 Printer/cartridge mismatch
52 Flash full
54 Network error
80 Maintenance kit
84 Imaging unit low
88 Toner cartridge low
Action
1
Check if the toner cartridge is supported. Replace
with a supported toner cartridge if necessary.
2
If the problem remains, go to
mismatch service check" on page
Format the flash memory:
Settings > Print Settings > Utilities > Format Flash
If the problem remains:
1
Remove the installed memory, and reset the
printer. If the problem does not reoccur, replace
the memory card.
2
If the problem remains, replace the controller
board.
Make sure the printer is properly setup on the
network.
If the problem remains:
1
Remove the wireless network option, and reset
the printer. If the problem does not reoccur,
replace the wireless network option.
2
If the problem remains, replace the controller
board.
Replace the maintenance kit, and then reset the
Maintenance counter.
1
Replace the imaging unit.
2
Make sure the imaging unit smart chip contact
cable is properly connected to the controller
board.
3
Make sure the contacts are free of debris.
4
Check the contacts for damaged pins. If damaged,
replace the printer.
5
If the contacts are free of damage, contact your
next level of support.
1
Make sure the toner cartridge smart chip contact
cable JARW1 is properly connected to the
controller board.
2
Make sure the contacts are free of debris.
3
Check the contacts for damaged pins. If damaged,
replace the toner cartridge smart chip contact.
4
If the contacts are free of damage, contact your
next level of support.
Diagnostic information
104
7016
"Printer/cartridge
105.