Fax Low Power Support; Min Copy Memory; Num Pad Job Assist; Format Fax Storage - Lexmark MX610 Service Manual

To change the setting:
1
From the Configuration menu, navigate to Energy Conserve.
2
Select On or Off.
If On (default), then the Sleep Mode cannot be turned off. If Off, then Disabled appears on the Sleep Mode
menu, and it can be turned off.

Fax low power support

Fax Low Power support allows you to select one of three power settings for the fax. The Auto value relies on the
firmware's logic to determine if the device supports the fax portion of the low power architecture. Permit Sleep allows
the fax chip to enter low power mode whenever the device determines that it should. Disable Sleep prohibits the fax
chip from ever entering low power mode.
To change the fax low power support setting:
1
Select Fax low-power support in the configuration menu to open the item
2
Select one of the three settings: disable, sleep permit, or sleep auto.
3
Select to accept the setting, or press the X on the screen to exit the item.

Min copy memory

Values will be displayed only if the amount of installed DRAM is at least twice the amount of the value, that is, at least
200 MB of installed DRAM is required to display the 100 MB selection.
To change this setting:
1
Select Min Copy Memory from the Configuration Menu. [setting's current value] displays.
2
Select the desired setting from the following values: 25, 35, 50, 80, 100.
3
Select Submit to save the change.

Num pad job assist

This setting determines if a user can configure and initiate a job using the operator panel's hard buttons.
To change this setting:
1
Select Num Pad Job Assist from the Configuration Menu. [setting's current value] displays.
2
Select the minus to decrease the setting's value or the plus to increase the setting's value.
3
Select Submit to save the change.

Format fax storage

This setting enables you to format the non-volatile storage used for storing faxes.
Service menus
189
7016