Mitsubishi 1989-1993 GALANT Service Manual page 102

ENGINE <SOHC>
(7) If the clearance between the tensioner arm and the
auto tensioner body cannot be measured (when the
engine is being mounted, etc.), the following proce-
dures can be used to substitute for the ordinary
method of measurement.
screwing it in until the push rod of the auto ten-
sioner body is caused to move backward and the
tensioner arm contacts the auto tensioner body.
Check to be sure that the amount that the tool has
been screwed in (when the push rod moves back-
ward) is the standard value.
Standard value: 2.5-3 turns
.
(8) Install the rubber plug to the timing belt rear cover
10. INSTALLATION OF TIMING BELT LOWER COVER/S.
The dimensions of the installation bolts for the timing co-
vers differ according to the installation location, so be sure
not to install the bolts in the incorrect locations.
TSB Revision
U P P E R