Mitsubishi 1989-1993 GALANT Service Manual page 132

SEALING POINTS
Intake cam-
Dowel pin shaft sprocket
Crankshatt
, _
ENGINE <DOHC> - Timing Belt
0 1 A0583
SERVICE POINTS OF REMOVAL
3. REMOVAL OF ENGINE MOUNT BRACKET
(1) With a wooden block placed against the oil pan part of
the
Caution
Jack up gently, so as not to apply a load to the
various parts.
(2) Remove the engine mount bracket.
4. REMOVAL OF DRIVE BELT
I
Before removing the drive belt, loosen the water pump
pulley mounting bolts.
19. REMOVAL OF AUTO TENSIONER
(1) Turn the crankshaft clockwise and align the timing
marks so as to bring the No. 1 cylinder to compresslon
top-dead-centre position.
At this
and the upper surface of the cylinder head should
coincide, and the dowel pin of the camshaft sprocket
should be at the upper side.
Caution
The crankshaft must always be rotated clockwise.
(2) Remove the auto tensioner.
Timing 1
TSB Revision
Sealant: 3M ATD Part No.8660
or equivalent
jack up the vehicle.
engine,
the timing marks of the camshaft sprocket
time