Mitsubishi 1989-1993 GALANT Service Manual page 120

ENGINE <DOHC>
Dowel Din
circumference
a t hoising side
(2) The camshaft's dowel pins should be at the positions
CAPS
Tighten the bearing cap installation bolts to the specified
torque in two or three steps.
Caution
Tighten uniformly, otherwise the rocker arms will not
be straight.
13. INSTALLATION OF CAMSHAFT OIL SEALS
Using the special tool, press in the oil seal as shown in the
figure.
SENSOR
Mating
mark
(1) Align the mating mark (punch mark) on the housing of
at plate side
(2) Install the crankshaft position sensor to the engine.
When tightening the nut of the crankshaft posi-
tion sensor, make sure that the crankshaft posi-
tion sensor does not turn.
(3) Check that the ignition timing is set at the standard
value. (Refer to GROUP 16-Ignition system.)
TSB Revision
Install new camshafts using the following procedure.
(2) Lay the camshafts on the cylinder head and install
the bearing caps.
(3) Check that the camshaft can be easily turned by
hand.
(4) After checking, remove the bearing caps and the
camshafts, and install the rocker arms.
shown in the figure.
the crankshaft position sensor with the mating mark
(notch) in the plate.
Caution
POSITION