Chapter 3. Messages Message Displays; Message List; Figure 3.3 Error Message During Startup - Kodak Versamark DS5600 Series Operator's Manual

Chapter 3. Messages
Message Displays
Message Displays
Messages

Message List

Check External Containers
Explanation:
Action:
44 DS5600 Series Printing Systems
Errors are displayed in red text on the screen. Errors prevent printing by
taking the print station out of 'Ready to Print' status or by preventing it
from being put in that status (the 'Ready' selection inactive). Figure 3.3
shows a sample error message displayed during startup.
When any error occurs, press
then press to clear the error. Serious errors cannot be cleared by
F8
pressing . If such an error occurs, contact your service technician or
F8
contact Kodak technical support.
Figure 3.3 Error message during startup
< Print Station Initialization >
Disk Drive check available_bytes
Checking Station Type
Loading Station Data
Printhead Communication
Printhead Communication
Printhead Communication
Printhead Communication
Printhead Communication
Loading Ink Data
Loading Ink Data
Loading Configuration
Reading States Table
Loading Help
Loading Error Help
Loading O.T. Messages
Charge Short Testing
Checking Station Speed
30 seconds Calibration
Pending error(s). Press any key to continue.
Messages are listed in alphabetical order. When more than one cause is
listed, the first is the most likely cause of the message. When more than
one action is given, each action should be taken in numerical order.
The ink level has remained incorrect for 5 minutes. Possible cause: 1.
empty external supply; 2. tubing from external supplies; 3. external ink or
replenisher supply solenoid; 4. fluid controller board; 5. ink level switch.
1. Check the external supplies of ink and replenisher, and replace if
necessary.
2. Check the tubing from the external supplies for kinks or breaks.
3. If the error recurs, have a service technician run diagnostics to check
the solenoids and switches.
to display information about the error,
F2
FLUID.TBL
INKTYPE.VAL
INKDEX.DAT
MACHINE.INI
STATESEQ.TBL
FLUIDHLP.001
ERRORHLP.001
MESSAGE.001
Calibration failed.