Startup Sequence; Figure 2.2 Network Hub And Power Connections, Dt3 Print Station - Kodak Versamark DS5600 Series Operator's Manual

Chapter 2. Operation
Startup Procedures
Up to four data outputs
Single Data input from controller
CS150 power
DT3 cabinet power
DT3 input power,
PC and monitor power
20 DS5600 Series Printing Systems
The DS5600 series controller on the DT3 cabinet requires the following
connections:
• Input power
• Monitor
• Keyboard
• Mouse
• Feature key (see note below)
• Data source
One input from the customer data source is required. The data source
is typically a LAN or network drive.
• Network hub data connections
Each printer or print station must have an output cable from the
24-port Ethernet switch installed in the system enclosure or the DT3
shelf (Figure 1.2). Input to the hub is a connection to the system
controller. Hub connections are done at installation and should not be
changed unless a printer is added to the system or permanently
removed. A connected printer does not have to be used. Only printers
active in the current software configuration print.
Note: The CS150 software key (also called a "feature key") is programmed for
the number of printheads and optional software features of the system. If
a feature is not active that is required, contact technical support.

Startup Sequence

Start the system using this sequence (Figure 2.1 and Figure 2.2):
• Power up the print station(s)
• Power up the narrow-format printer(s)
• Power up the network hub
• Power up the controller PC
Figure 2.2 Network hub and power connections, DT3 print station