Startup Procedures; System Connections; Figure 2.1 Connections, Cs150 Controller On Dt3 Cabinet - Kodak Versamark DS5600 Series Operator's Manual

Startup Procedures

Monitor power
Data from controller
Data out to printer
Data from customer network
PC power
KVM for CS150
CS150 software key
KVM switch input
KVM switch
KVM for DT3
Data output
The CS150 System Controller is primarily used with the Kodak Versamark
D-Series Printing Systems for applications that require bar coding,
numbering, addressing, and personalizing. The CS150 can operate up to
four printheads in various combinations (See "DS5600 Configurations" on
page 11). The feature key for the CS150 software must match the number
and type of printheads being used.
Narrow-format printers should be powered-up normally before the
controller is started. For a system a with DS5000 series enclosure, startup
is done exactly the same as described in the Kodak Versamark CS150
System Controller Software Getting Started Guide. Review the following
procedures before starting the system initially:
•

System Connections

• Startup Sequence
System Connections
For a system without a DS5000 series enclosure, check all the
connections to the controller mounted under the shelf on the DT3 cabinet
(Figure 2.1).
Figure 2.1 Connections, CS150 controller on DT3 cabinet
Chapter 2. Operation
Startup Procedures
Operator Guide 19