Standby; Setup Menu Procedures; Figure 2.21 Setup Menu, Dt3 Print Station Software - Kodak Versamark DS5600 Series Operator's Manual

9. Print test patterns at the expected job speed. Check the results for
pickout and dark defect.
Caution: Do not change the center point of the pressure by more than 1.5 psi
(10.3 kPa).
Note: The range of 10 VDC above and 10 VDC below the center point for equal
a total range of 20 VDC. Extreme cases of pickout or dark defect may
need changes of 5 to 10 VDC to correct printhead performance. Small
changes of about 2 VDC can correct minor cases of pickout or dark
defect.
Use the following procedure to change the center point of the operator
charge voltage adjustment range:
1. Divide the pressure range by 2.
2. Add the result to the lower pressure.
3. Set the center point of the range to this result.
4. Press E
SC
return to the Control Menu screen.
5. Print test patterns at the expected job speed. Check the results for
pickout, dark defect, or ghosting.
6. Print test patterns at the expected job speed. Check the results for
ghosting.

Standby

Select Standby to circulate ink through the print station and printhead.
Note: Ink circulation can also be accomplished by pressing C
while the print station is powered up and ready for operation.

Setup Menu Procedures

Use the selections on Setup Menu (Figure 2.21) only after consulting a
service technician or technical support.
Figure 2.21
Choose a function, enter the number
Press F1/F2 key for HELP.
, then select Service Menu (9) and Control Menu (8) to
Setup Menu, DT3 print station software
** SETUP MENU **
Function Selections
1 PH Height
2 Ink Number
3 Concentration
4 System Language
5 Help Language
6 O.T. Language
7 ---------
8 Parameters menu
9 ---------
Chapter 2. Operation
Print Station Operation
+ Z any time
TRL
Operator Guide 41